単結晶ダイヤモンド二次元切削における工具すくい面温度の測定

フォーマット:

論文

責任表示:

佐藤, 昌彦 ; 上田, 隆司 ; 西田, 昌弘

言語:

日本語

出版情報:

精密工学会 = The Japan Society for Precision Engineering, 1998-01-01

著者名:

• 佐藤, 昌彦
• 上田, 隆司
• 西田, 昌弘

掲載情報:

精密工学会誌 = Journal of the Japan Society of Precision Engineering

ISSN:

0912-0289      

巻:

64

通号:

6

開始ページ:

892

終了ページ:

896

バージョン:

publisher

概要:

Tool face temperature of single crystal diamond in high precision orthogonal cutting of aluminum and copper is measured using two-color pyrometer with an optical fiber. The infrared rays radiated from the chip-tool interface and transmitted through the diamond tool are accepted by an optical fiber and led to two-color detectors of different spectral sensitivity. Temperature distribution on the tool face is analyzed by employing finite element method and calculated … results are applied to the estimation of the maximum temperature on the tool face. The results obtained are as follows; (1) The technique developed is suitable for measuring the tool face temperature in single crystal diamond cutting. (2) Output wave of temperature was clearly recorded. The tool face temperature measured is approximately 190°C for Al and approximately 220°C for Cu when cutting speed was about 620m/min. (3) The temperature increases with the increase of cutting speed. (4) The temperature on the tool face measured is in good agreement with that calculated. 続きを見る

URL:

http://hdl.handle.net/2297/38805