1.

論文

論文
上田, 隆司 ; 佐藤, 昌彦 ; 杉田, 忠彰
出版情報: 精密工学会誌 = Journal of the Japan Society of Precision Engineering.  62  pp.120-124,  1996-01-01.  精密工学会 = The Japan Society for Precision Engineering
URL: http://hdl.handle.net/2297/38765
概要: The influence of cutting speed, and thermal properties of the work material and the tool material on the thermal partition coefficient is investigated theoretically and experimentally. The temperature at the top of a conical tool is measured immediately after micro chip forming using an infrared radiation pyrometer with an optical fiber. A carbon steel, a titanium, a molybdenum and a tungsten are used as work materials, and a silicon nitride Si3N4, a zirconia ZrO2 and a diamond are used as tool materials. The cutting temperature increases in proportion to the 1/2 power of cutting speed and saturates to the melting point of work material. The fraction of heat conducted into the cutting tool is independent on the cutting speed, and it becomes larger as the thermal conductivity of workpiece is smaller or that of tool material is larger. In the diamond tool which has the highest thermal conductivity, its thermal partition coefficient is the highest, but the tool tip temperature is the lowest. 続きを見る
2.

論文

論文
米山, 猛 ; 陸, 子男
出版情報: 精密工学会誌 = Journal of the Japan Society for Precision Engineering.  64  pp.598-602,  1998-01-01.  精密工学会 = The Japan Society for Precision Engineering
URL: http://hdl.handle.net/2297/41932
概要: As trial applications of mechanical machining for micro parts production, a micro lathe turning system has been constructed. The size of the micro cutting system is so small that the working situation must be observed under an optical microscope. Circular bar of 0.3mm in diameter is cramped and rotated with little eccentricity. Several materials such as copper, brass and Ti are cut into the minimum size of about 10 μ m in diameter. And also the influence that is given to cutting force under several cut conditions has been discussed. Especially, the influence of the depth of cut and the feed of cut on the cutting force and the specific cutting force has been investigated in the cutting process of each material. 続きを見る