※一部利用できない機能があります
| 1.
論文 |
論文
|
田中, 隆太郎 ; 細川, 晃 ; 山田, 啓司 ; 上田, 隆司 ; 林, 勇伝 ; Tanaka, Ryutaro ; Hosokawa, Akira ; Yamada, Keiji ; Ueda, Takashi ; Lin, Yongchuan
概要:
金沢大学理工研究域機械工学系<br />This study deals with the machinability of steels in turning with additional current. Tested work ma
…
terials were plane carbon steel JIS S45C and BN added steel which has good machinability at high cutting speed. Turning tests were performed by carbide tool P30 in order to investigate the influence of electrical conditions of closed circuit system on the cutting mechanism of BN added steel. The tool life and cutting force was investigated practically and these results were discussed. 従来,鋼の被削性を改善するために快削性添加物や鋼中の介在物の組成や形態を制御するなど多くの快削鋼が研究·開発がされてきた.その中のひとつであるBN添加鋼は切削中にベラーグと呼ばれる保護膜を摩耗面上に形成し,高速域で標準鋼に比べ工具摩耗を大幅に抑制する.本研究ではこのBN添加鋼を最大20mAの微量通電下で超硬工具による旋削加工を行い電流量と摩耗量の関係を調べ,その摩耗抑制効果について検討を行った.<br />出版者照会後に全文公開
続きを見る
|
||||
| 2.
論文 |
論文
|
田中, 隆太郎 ; 上田, 隆司 ; 細川, 晃 ; 林, 勇伝 ; 山田, 啓司
概要:
This study deals with the machinability of steels after heat treatment with CO2, laser using h-BN powder and blast furna
…
ce slug as absorbent. h-BN is well known as solid lubricant. As for blast furnace slug, its composition is similar to that of inclusions in calcium dioxide steel that shows good machinability. The absorbance of slug and h-BN were more than 80%, so it is said that these powders can be used as absorbent for CO2, laser. Only in the case of h-BN, absorbent was melted into substrate and its depth was about 200 μm. When turning the steels after laser heat treatment using h-BN power and blast furnace slug as absorbent, carbide tool showed smaller tool wear than the case of carbon type absorbent. In the profile of the machined surface, there was a wave of about 5 μm in amplitude and its wavelength was equal to the feed rate of laser in heat treatment. This is because the workpiece surface after laser heat treatment has a periodic distribution in hardness. The hardness in the surface layer of workpiece was higher than that of the substrate.
続きを見る
|
